Cleaner and disinfectant for massage tubs, biocide

DINASAN P is a cleaner and disinfectant to be used on massage tubs, in its plumbing system and jets.

By using the product, stains from hard-to-reach places can be removed. These areas serve as a breeding ground for organic contaminants because of the presence of biofilm, oils, soap and greasy precipitates. The product performs very well at places where mechanic cleaning can not be done easily.
Also perfect for surface cleaning, it removes slimy stains, soap residues, oily and greasy precipitates from swimming-pool walls effectively. As these stains often cause foaming in the pool, the product can successfully eliminate foaming, too.

APPLICATION:
Before letting the water out to drain, add 250 gr of DINASAN P to each m3 of water into the filter unit.
If dosing into the skimmer or filter unit is not possible, dissolve the needed quantity in approx. 5 liters of water and pour it directly into the massage tub.
After adding the product circulate the water for at least 5 minutes.
Stop the pump, then let the product work at least for an hour, until it loosens the stains. Then assure 1 more hour for the disinfection.
After the contact time is over, circulate the water again for a few minutes.
Let the water into the drain and rinse the tub.
Refill the tub with a small amount of water and let it circulate in the system for 5 minutes to remove the residual chemical from the plumbing system.
Let the rinsing water down to drain.

TIP: Hot water enhances the cleaning effect. 

CLEANING OF SURFACES:
DINASAN P is also suitable for cleaning the surfaces of the massage tub as follows:
Let down the water into the drain.
Wet the walls of the tub.
Spread the product directly on the surface, then use a plastic brush to sscrub the area to be cleaned.
Rinse the product from the surface (use hot water if possible)

IMPORTANT:
The product can only be used to clean tub surfaces. Do not use it on surfaces not resistant to alkalines (e.g. on aluminium). If the product gets onto such surfaces, rinse it with a lot of water.

PERIODIC MAINTENANCE:
For periodic maintenance of whirlpools (every 5 to 8 weeks) besides DINASAN P use the following products:
- Alga-sokk P 
- Dinax Filter Cleaner F 
- Dinax Filter Fizzy P

TREATMENT OF WHIRLPOOLS AND RESIDENTIAL POOLS:
Recommended products:
- Dewan-18  – chlorine-free disinfectant (liquid)
- Blue Super Tabs WP  – chlorine-based, combined disinfectant tablet, 3:1 (disinfection, flocculation, algae removal)
- Alga-sokk WP  – chlorine-based disinfection tablet
- Dinax Minus P – pH-reducer granules

OTHER PRODUCTS:
- Dinax Habstop F  – anti-foaming liquid
- Dinax Filter Fizzy P – filter cleaner granules
- Dinax Filter Cleaner  – filter cleaner liquid
- Dinax Metal Magic F  – to remove metallic, limescale precipitates, to prevent brownish discolouration of poolwater

AVAILABLE PRODUCT SIZES: 
DINASAN P 1 kg 

Consult the safety instructions before using disinfectants. Before using a chemical always consult the product label and the instructions for use.